Generator autostart

Would like to be able to start and stop a generator using just one input (1) Outputs needed [login to view URL] control (linear actuator) [login to view URL] control ( linear actuator) [login to view URL] (relay) [login to view URL] (relay) [login to view URL] (relay) [login to view URL] sensor grid side (relay) 8. voltage sensor gen side (relay) 9. Output on (relay) 10. Shutdown (relay) Would ideally just set timers for all these things dependant on the particular machine I'm setting it up for eg. Start time may be different for differnt generators, throttle length might be different Need remote access through ip address to be able to change these values can be done in cmd Also ability to call in generator remotely through web and have redundant start up in case of certain value (grid failure) Program might run something like 1=high Then 3,4,5 on 8=high 5 off Wait 15sec then 3 off Wait 2min (warm up) 9 on (shutdown sequence) 1=low 9 off 2 throttle down Wait 30sec 6 4 off If remote start called in from web Start above sequence If 7 low Start above start up sequence until 10. High Then Run shutdown sequence