Hi.
I'm attempting to get my NFC chip to read correctly.
The NFC chip has an inbuilt temperature sensor, I can successfully read the chip's ID, however I can't get any of the other information from the chip itself.
Below is the code which reads the Chip.
I'm told that I need to send a RAT code to get a response from the chip.
Details for the Arduino Reader are here:
[login to view URL]
The chip itself is a FDX-B type chip.
---- My half Working Code -----
#include <SoftwareSerial.h>
SoftwareSerial mySerial(8, 9); // RX, TX
void setup()
{
// Open connection to host at 38400bps
[login to view URL](9600);
// Open connection to RFID module at 9600bps
[login to view URL](9600);
}
void loop()
{
if ([login to view URL]())
[login to view URL]([login to view URL]());
if ([login to view URL]())
[login to view URL]([login to view URL]());
}